Motion VELOCE Podręcznik Użytkownika Pobierz pdf (Strona 11)

Veloce 50 Operating Manual

4 TAKING MEASUREMENTS

4.1 MATING THE TRANSDUCERS TO THE VELOCE CONDITIONER

To use a transducer with the Veloce conditioner, simply mate the fiber optic transducer connector with the

Veloce input connector. Once the transducer is connected, simply press the reset button and valid

readings of the transducer will be present at the Analog Output connector. See section 6 for converting

the voltage output value to the measured physical parameter value.

For proper use of the fiber optic transducers, the transducer fiber optic connectors must be kept clean and

free of dust at all times. Any dust may obstruct the light transmitted from one connector to the other, and

reduce the signal-to-noise ratio to an unusable level. IT IS A GOOD PRACTICE TO ALWAYS CLEAN

THE TRANSDUCER CONNECTOR BEFORE MATING IT TO THE CONDITIONER (SEE SECTION 6).

Transducer connectors are cleaned by wiping its end with low lint tissue such as Kimwipes® or lens

cleaning tissue. Keeping the transducer connectors clean also prevents the contamination of the Veloce

input connector. However, it is also recommended to clean the Veloce input connector once in a while.

Use the specially designed 2.5 mm Mini Foam Swab provided with Fiso Cleaning Kit (Part n° FTI-M) for

cleaning the input connector of Veloce.

4.2 USING THE FIBER-OPTIC TRANSDUCERS

Additional information are available on specific fiber-optic transducers. Ask for Fiso Technologies specific

technical note and installation guide such as Fiso Fiber-Optic Strain Gauge Installation Guide.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 29 30

Brak uwag

Motion VELOCE Podręcznik Użytkownika Strona 11